Space Saving… Low Energy Consumption… Rapid Cycle…
A 1700°C programmable sintering furnace with optional datalogger and gas port and slightly larger 1600 °C models.
Hot Spot 110 Lab Furnace
We manufacture the highest quality ceramics which create durable setters, trays and lab furnaces for sintering up 1700C
Space Saving… Low Energy Consumption… Rapid Cycle…
The Hot Spot 110 is offered in two models and can rapidly achieve temperatures up to 1700 °C.
Hot Spot 110 Accessories
Shelf System
Calibration Rings
Datalogger
Setter Plates
Setter Spatula
Hot Spot 110 Repair Parts
Thermocouples
Heating Elements
Element Holders
Element Straps
Hot Face Insulation
Procedure for Replacing HotSpot Thermocouple
Dental Lab Supplies
Sintering Trays and ZDB For Hot Spot 110 Lab Furnace
Sintering Trays… Low Mass & High Density Options… Support Media…
Essentials for the dental lab.
Hard Cast Heaters
Ceramic Heater Plates
Heaters offer 1100 °C operating temperature, up to 2500 w/ft²
The six Hard Cast Heaters used to power this 30” wide x 18” tall x 36” deep front loaded box furnace, are of the embedded wire type. The 480 V three phase HCH set delivers 60 KW of power, an average of 2500 watts per square foot. This 11.25 cubic foot production furnace is fired to 1100 °C two to three times a week. The roof and wall heaters are set up to radiate directly into the furnace chamber. The two heaters on the floor are oriented to radiate into a space below the heater. The roof is suspended by refractory hangers which are supported on the outside roof structure.